68 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
Pre-alarm time [sec.]: Select the pre-alarm time for the alarm and motion recording.
Note:
The maximum pre-alarm time is 1800 seconds. The pre-alarm
time depends on the recording rate of the pre-alarm
recording. A maximum of 3600 images can be recorded for
each pre-alarm and by each camera. Example: 1image/
second = 1800 seconds, 2 images/second = 1800 seconds,
4 images/second = 900 seconds, 5 images/second =
720 seconds etc.
5 Alarm recording Make the settings for alarm recording.
Rate: Select the recording rate.
Note:
The actual recording rate depends on the camera type and
the parameters set for the camera (e.g.: resolution,
compression setting).
Post-alarm time
[secs.]:
Enter the post-alarm time.
Note:
The maximum post-alarm time is 999 seconds. The default
setting is 0 seconds.
6 Continuous recording Make the settings for continuous recording.
Rate: Select the recording rate.
Note:
The actual recording rate depends on the camera type and
the parameters set for the camera (e.g.: resolution,
compression setting).
7 Delete old video Activate this check box to automatically delete data after a
specified number of days.
Older than [days]: Enter the number of days after which data should be deleted.
Example: 3 means that all data older than 3 days is
automatically deleted.
Delete protected data: Check box is activated: Protected data is automatically
deleted after a specified number of days.
Check box is not activated: protected data is not
automatically deleted.
8 Default settings Click the button to see the default settings.
9 Copy settings to other
time periods...
Copies all tabs from the selected time period with all the
settings they contain into other time periods.
Click the button. A dialog box opens where you can select the
time periods.
10 Save The entries are saved.
To Next Page
Loading...
