Installation workflow
Before installing and operating the control panel, read these instructions. Failure to follow
these procedures may cause the device not to function properly. Bosch Security Systems Inc.
is not responsible for any devices that are improperly installed, tested, or maintained.
This document does not contain special information about local requirements and safety
issues. Information on such issues is provided only to the extent that it is needed for
operation of the device. Ensure that you are familiar with all safety-related processes and
regulations in your area. This also includes how to act in the event of an alarm and the initial
steps to take if a fire breaks out. The operating instructions should always be available on site.
It is a required part of the system and must be given to the new owner if the system is ever
sold.
Use the workflow and checkboxes below as you complete steps.
Install the enclosure
Install the control panel
Install and wire for telephone communication
Install and wire for IP communications
Install and wire the transformer
Install and wire arming devices
Install and wire outputs
Install and wire inputs
Complete the installation
See also
– Install the transformer, page 24
– Communication Information, page 68
– B426/B426-M Conettix Ethernet Communication Modules, page 21
– B450/B450-M Conettix Plug-in Communicator Interfaces, page 21
– Codepads, page 14
– RADION keyfobs, page 19
– Keyswitches, page 23
– WE800EV2 receiver, page 18
– B308 Octo-output Module, page 20
3
Control Panel Installation workflow | en 13
Bosch Security Systems, Inc. Installation Guide 2017.10 | 03 | F.01U.298.026