Bosch Solution 2000 Installation Guide

Configuration
Installer Commands
When working with an ICON codepad, there are nine commands in Installer’s Programming
Mode. To issue a command, enter the command number and press [#].
When working with an alphanumeric codepad, select the menu and issue a command after
entering the Installer Menu.
Command Description
958 Exit from Installer’s Programming Mode without saving changes
959 Test IUI-SOL-ADAPTER
960 Exit from Installer’s Programming Mode with saving changes and system
reset
961 Reset the control panel to factory defaults
962 Copy the control panel memory to IUI-SOL-ADAPTER
963 Copy IUI-SOL-ADAPTER data to the control panel memory
965 Set up domestic dialing format
966 Enable/disable the automatic stepping of locations during programming
999 Display the control panel firmware version number
Table 5.1: Installer’s Programming Commands
Command 958 - Exit from Installer's Programming Mode without saving
changes
This command exits from Installer’s Programming Mode. You can exit from Installer’s
Programming Mode from any location.
To exit from Installer’s Programming Mode:
Enter [9 6 0 #]. The system returns to the disarmed state. When using the codepad, the STAY
and AWAY indicators are extinguished.
Command 959 - Test IUI-SOL-ADAPTER
This command initiates a test of the direct link adapter. You can only use the IUI-SOL-
ADAPTER Direct Link Adapter with the control panel.
The direct link adapter test is non-destructive, and any data in the direct link adapter remains
after the test is completed. One long beep indicates that the direct link adapter test failed.
Two beeps indicates a successful test.
If you remove the direct link adapter before the test is finished, the direct link adapter data
becomes corrupt. Do not remove the direct link adapter while the activity LED is lit or pulsing
rapidly.
To test the direct link adapter:
1. Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s
Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the
codepad to indicate you entered Installer’s Programming Mode. The codepad displays the
data stored in Location 000.
5
5.1
5.1.1
5.1.2
Control Panel Configuration | en 25
Bosch Security Systems, Inc. Installation Guide 2017.10 | 03 | F.01U.298.026

Bosch Solution 2000 Specifications

General

Zones	8
Expandable Zones	Up to 16
Event Log	100 events
Partitions	2
Battery Backup	Yes
Weight	2.5kg
Backup Battery	12V 7Ah
Arming Options	Stay, Away
Communication	PSTN (optional IP module)