Adding Remote Radio User Codes
This function allows a Master Code holder to add a remote radio User Code ( RF keyfob).
To Add a WE800EV2 Keyfob
Set RF receiver as WE800EV2 Receiver. Confirm that the keyfob has been added to the
WE800EV2 receiver. Refer to WE800EV2 receiver, page 18 – Add/delete keyfobs.
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
2. Enter the WE800EV2 keyfob number (301 to 332) you want to add, followed by the [#]
button. Up to 21 WE800EV2 keyfobs can be added, but only current keyfob number (1 to
16 ) displays through zone indicators on the ICON codepad.
3. Only use auto-learn mode to configure keyfob RFID. Press [*] button to switch into auto-
learn mode. When icon numbers (1 to 16) flash, press button 1 or 2 of the keyfob. The
control panel learns the WE800EV2 keyfob ID number and the last digit of RFID number
displays on the codepad. Press [#] button to confirm.
4. Enter [#] button to confirm the operation, or press [*] to cancel.
To Add a RADION keyfob
Set RF receiver as RADION Receiver.
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
2. Enter the RADION keyfob number (301 to 332) you want to add, followed by the [#]
button. Up to 32 RADION keyfobs can be added, but only current keyfob number (1 to
16 ) displays through zone indicators on the ICON codepad.
3. Use manual mode or auto-learn mode to configure the RADION keyfob RFID.
– In manual mode, enter the 9-digit RF device ID number followed by [#], or press [*]
to switch into auto-learn mode. When icon numbers (1 to 16) flash, press the 1 or 2
button on the keyfob. The control panel learns the RADION keyfob ID number and
the last digit of RFID number displays on the codepad. Press [#] to confirm.
4. Press [#] to confirm the operation, or press [*] to cancel.
Deleting User/Radio Codes
Only the Master Code holder can delete other system user codes.
To Delete a User Code
1. Enter your Master Code, followed by [1] and the [#] button (for example,
[25801#]).Three beeps sound and the STAY and AWAY indicators flash.
2. Enter the user code number (1 to 32), followed by the [#] button (for example, [2#] =
User 2, [16#] = User 16). Two beeps sound and the selected user number displays on the
codepad indicators.
3. Press the [*] button to delete the selected User Code. Two beeps are heard and the STAY
and AWAY indicators turn off.
4. To delete other User Codes, repeat this procedure as many times as required.
To Delete a WE800EV2 Keyfob
1. Enter your Master Code, followed by [1] and the [#] button.
2. Enter the WE800EV2 keyfob number (301 to 332) you want to delete, followed by the [#]
button.
3. Press the [*] button to delete the WE800EV2 Keyfob.
To Delete a RADION Keyfob
1. Enter your Master Code, followed by [1] and the [#] button.
7.2.4
7.2.5
Control Panel System Functions | en 53
Bosch Security Systems, Inc. Installation Guide 2017.10 | 03 | F.01U.298.026
To Next Page
Loading...
Need help?
General
