6.6 Disarming the system from STAY Mode 2 34
6.7 Codepad duress alarm 34
6.8 Codepad panic alarm 34
6.9 Codepad fire alarm 35
6.10 Codepad medical alarm 35
6.11 Isolating zones 35
6.11.1 Standard isolating 35
6.11.2 Code to isolate 36
6.12 Fault analysis mode 36
6.13 Fault descriptions 37
6.14 Inquire cloud status 39
7
System Functions 41
7.1 Installer Code Functions 41
7.1.1 Add or Delete RF Wireless Devices 41
7.1.2 Add/Delete RF Repeater 42
7.1.3 Add/Delete RF Keyfob 43
7.1.4 Set the Number of Days until the First Test Report 45
7.1.5 Change Domestic Phone Numbers 45
7.1.6 Change Telco Arm/Disarm Sequence 46
7.1.7 Setting STAY Mode 2 Bypass Zones 47
7.1.8 Turning Report Monitor Mode On and Off 48
7.1.9 Walk Test Mode 49
7.1.10 Event Memory Recall Mode 49
7.1.11 AWAY/STAY 1 Arm/Disarm 50
7.2 Master Code Functions 51
7.2.1 Arm or Disarm both Areas at the Same Time 51
7.2.2 Arm or Disarm Single Area 51
7.2.3 Changing and Deleting User Codes 52
7.2.4 Adding Remote Radio User Codes 53
7.2.5 Deleting User/Radio Codes 53
7.2.6 Change Domestic Phone Numbers 54
7.2.7 Change Telco Arm/Disarm Sequence 54
7.2.8 Setting STAY Mode 2 Bypass Zone 54
7.2.9 Turning Outputs On and Off 54
7.2.10 Setting the Date and Time 55
7.2.11 Walk Test Mode 55
7.2.12 Event Memory Recall Mode 55
7.2.13 System reset 55
7.3 User Code Functions 55
7.3.1 Arm or Disarm both Areas at the Same Time 55
7.3.2 Arm or Disarm Single Area 56
7.4 Hold-Down Functions 56
7.4.1 Arm the System in AWAY Mode 56
7.4.2 Arm the System in STAY Mode 1 56
7.4.3 Arm the System in STAY Mode 2 56
7.4.4 Horn Speaker Test 57
7.4.5 Bell Test 57
7.4.6 Strobe Test 57
7.4.7 Turning Day Alarm On and Off 57
4 en | Table of Contents Control Panel
2017.10 | 03 | F.01U.298.026 Installation Guide Bosch Security Systems, Inc.
To Next Page
Loading...
Need help?
General
