Add RADION Keyfob
Notice!
Solution 2000 does not support RADION keyfobs.
Set RF receiver as RADION Receiver B810 (Value 1 in Location 395).
1. Enter the Master Code, followed by [1] and the [#] key (for example, [25801#]).
2. Enter the RADION keyfob number (301 to 332) you want to add (301 = keyfob 1, 302 =
keyfob2, etc.), followed by the [#] key. Up to 32 RADION keyfobs can be added, but only
current keyfob number (1 to 16) displays through zone indicators on the ICON codepad.
3. Use manual mode or auto mode to configure RADION keyfob RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] key.
– Or press [#] key to switch into auto mode. When icon numbers (1 to 16) flash, press
button 1 or 2 of the keyfob. The panel learns the RADION Keyfob ID number and the
last digit of RFID number displays on the codepad. Press [#] key to confirm.
4. Enter [#] key to confirm the operation, or press [*] to cancel.
Delete RADION Keyfob
1. Enter the Master Code, followed by [1] and the [#] key.
2. Enter the RADION keyfob number (301 to 332) you want to delete, followed by the [#]
key.
3. Press the [*] key to delete the RADION Keyfob.
Example:
To delete existing RADION keyfob 1: Enter your Master Code and press [1] [#] [3] [0] [1] [#]
[*].
7.1.3.2
More than 3 heading levels are not supported! Using an Alphanumeric codepad
Notice!
Set RF receiver as WE800EV2 or RADION receiver through the menu [3][5][1].
Add the Keyfob
1. Enter the Master Code, followed by [1] and the [#] key (for example, [25801#]).
2. Choose a user number then press the [#] key.
3. Choose keyfob then press the [#] key.
4. Keyfob RFID displays. The letter "M" appears in the top right corner of the display
indicating it is in manual mode.
– In manual mode, enter the 9-digit RADION keyfob RFID, followed by the [#] key.
– Or press [*] key to switch into auto mode to configure RADION or RE012EU keyfobs.
The letter ‘A’ should appear in the top right corner of the display indicating it is in
automatic mode. Hold button 1 or 2 of the keyfob till codepad displays RFID number.
Press [#] key to confirm.
5. Enter [#] key to confirm the operation, or press [*] to cancel.
6. Press menu [-] to exit.
Delete the keyfob
1. Enter the Master Code, followed by [1] and the [#] key.
2. Choose a user number then press the [#] key.
3. Choose keyfob then press the [#] key.
4. Press the [*] key to blank the RFID and then press the [#] to accept.
44 en | System Functions Control Panel
2017.10 | 03 | F.01U.298.026 Installation Guide Bosch Security Systems, Inc.
To Next Page
Loading...
Need help?
General
