Brother HL-5350DN

7-6
Confidential
Press the [Go] button twice.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button three times.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button more than 2 seconds (long push).
Check that Paper LED is lighted.
Press the [Go] button Mode
Once 17) Printing for Maintenance
* Start printing when close the front cover.
Twice 18) Maintenance + Test pattern with margin frame
(DX/LongBind)
(HL-5340 is the print test)
* Start printing when close the front cover.
Three times 19) Network Config Printing
(HL-5380DN is the print test)
* Start printing when close the front cover.
Four times 20) Sleep Mode Setting (ON/OFF)
* Check that all LEDs are lighted for one second.
Five times Ineffective
Six times 21) Developer Roller Counter Reset 2
(For the standard toner cartridge)
* Check that all LEDs are lighted for one second.
Seven times 21) Developer Roller Counter Reset 3
(For the high-capacity toner cartridge)
* Check that all LEDs are lighted for one second.
Eight times 22)Fixed USB Speed Mode
Nine times 23) USB Speed Indication (ON/OFF)
Ten times 24) Sleep Mode Indication (OFF/Dimmed)
More than 11 times Go back to Normal State
Press the [Go] button Mode
One to eight times,
ten to 12 times
Factory use
Nine times 25) Inspection Mode Clearance + Inspection Mode
Mask
PIT3 Inspection Mode * Factory use.
CAUTION;
• Each mode starts 2 seconds after pressing the [Go] button.
• If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is
released, the LED is out.