Name: Brother MFC-8480DN - B/W Laser - All-in-One
Brand: Brother
Rating: 4 (1 reviews)

To Next Page

To Previous Page

3-26

Confidential

■ Error code 8A

Paper jam (Tray 1)

Error code 8B

Paper jam (Tray 2)

Error code 8C

Paper jam (MP tray)

Jam Tray 1

Remove the jammed paper from Tray 1.

Jam Tray 2

Remove the jammed paper from Tray 2.

Jam MP Tray

Remove the jammed paper from Multi Purpose Tray and press Start.

• Check if the paper is jammed in the appropriate tray. If jammed, remove it.

• Adjust the paper guide corresponding to the paper size.

• Check if too much paper is loaded in the tray.

Step Cause Remedy

1 Dirt on edge sensor Clean the edge sensor.

Harness connection failure of high

voltage power supply PCB ASSY

Check the harness connection of the high

voltage power supply PCB ASSY in the

appropriate tray, and reconnect it.

Paper feeding kit worn out

(MP/ T1/ T2)

Replace the paper feeding kit of the

appropriate tray.

Registration front sensor failure procedure described in “Maintenance

mode 32”. If any problem occurs, replace

the high voltage power supply PCB ASSY.

5 Main PCB failure Replace the main PCB ASSY.

Other manuals for Brother MFC-8480DN - B/W Laser - All-in-One

Questions and Answers:

Need help?

Do you have a question about the Brother MFC-8480DN - B/W Laser - All-in-One and is the answer not in the manual?

General