Brother MFC-8480DN - B/W Laser - All-in-One User Manual

3-27
Confidential
■ Error code 8D
Paper jam near eject tray
■ Error code 99
Specified paper size is not supported for duplex printing (Duplex)
Cover is Open
Make sure there is no paper jammed inside the machine and close
the Back Cover, then press Start.
<User Check>
• Check if the paper is jammed in the back cover. If jammed, remove it.
Step Cause Remedy
1
Duplex sensor failure Check the sensor performance following
the procedure described in “Maintenance
mode 32”. If any problem occurs, replace
the relay rear PCB ASSY.
2 Main PCB failure Replace the main PCB ASSY.
Size mismatch DX
Press Job Cancel. Specify the correct paper and load the same
size paper as the Printer driver setting.
<User Check>
• Remove the jammed paper, and use the A4 size or letter size paper, and load the same
size paper as the printer driver setting.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.

Brother MFC-8480DN - B/W Laser - All-in-One Specifications

General

Printer Type	B/W Laser
Functions	Print, Copy, Scan, Fax
Scan Resolution	Up to 19200 x 19200 dpi (interpolated)
Automatic Duplex Printing	Yes
Connectivity	USB 2.0, Ethernet
Paper Input Capacity	250 sheets
Standard Paper Capacity	250 sheets
ADF Capacity	50 sheets
Print Speed	32 ppm
Copy Resolution	1200 x 600 dpi
Scan Type	Flatbed, ADF
Max Paper Size	Legal (8.5 in x 14 in)
Print Resolution	1200 x 1200 dpi
Copy Speed	Up to 32 cpm
Dimensions	531 mm x 451 mm x 475 mm