Name: Brother MFC-8480DN - B/W Laser - All-in-One
Brand: Brother
Rating: 4 (1 reviews)

To Next Page

To Previous Page

7-17

Confidential

(1) Press the [1] and [0] keys in this order in the initial stage of the maintenance mode.

The machine displays the "WSW00" on the LCD and becomes ready to accept a

firmware switch number.

(2) Enter the desired number from the firmware switch numbers (01 through 77).

The following appears on the LCD:

(3) Use the [ ] and [ ] buttons to move the cursor to the selector position to be modified.

(4) Enter a value to be set (0 or 1) using the [0] and [1] keys.

(5) Press the [OK] button. This operation saves the newly entered selector values onto the

EEPROM and readies the machine for accepting a firmware switch number.

(6) Repeat steps (2) through (5) until the modification for the desired firmware switches is

completed.

(7) Press the [Stop/Exit] button to return the machine to the initial stage of the maintenance

mode.

■ Details of Firmware Switches

• The details of the firmware switches are described in APPENDIX 1 in which the user-

accessible selectors of the firmware switches are shaded.

Note:

• To cancel this operation and return the machine to the initial stage of the

maintenance mode during the above procedure, press the [Stop/Exit] button.

• If there is a pause of more than one minute after a single-digit number is entered for

double-digit firmware switch numbers, the machine will automatically return to the

initial stage of the maintenance mode.

Selector 1 Selector 8

WSWXX = 0 0 0 0 0 0 0 0

Other manuals for Brother MFC-8480DN - B/W Laser - All-in-One

Questions and Answers:

Need help?

Do you have a question about the Brother MFC-8480DN - B/W Laser - All-in-One and is the answer not in the manual?

General