Brother MFC-J2330DW

Confidential
9.42 Switchback Sensor PCB......................................................................................3-96
9.43 CR Encoder Strip...............................................................................................3-101
9.44 Carriage Motor...................................................................................................3-102
9.45 Flushing Base....................................................................................................3-105
9.46 LT Frame ASSY ................................................................................................3-106
9.47 T2 Bank ASSY...................................................................................................3-109
9.48 Power Supply PCB ASSY .................................................................................3-110
9.49 Switchback Roller..............................................................................................3-112
9.50 PF Encoder Disk................................................................................................3-113
9.51 PF Encoder Sensor PCB...................................................................................3-114
9.52 Paper Feed Motor..............................................................................................3-116
9.53 Paper Feed Roller .............................................................................................3-118
9.54 Maintenance Unit...............................................................................................3-119
9.55 Ink Absorber Felt (For Maintenance Unit) .........................................................3-121
9.56 Platen/Paper Ejection Roller..............................................................................3-122
9.57 Registration Sensor PCB...................................................................................3-125
9.58 Flushing Box......................................................................................................3-128
9.59 Paper Feed Arm Frame ASSY..........................................................................3-128
9.60 T1 Bank ASSY...................................................................................................3-129
9.61 T1 Base Pad / T2 Base Pad..............................................................................3-131
CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT..............................................4-1
1 IF YOU REPLACE THE MAIN PCB...............................................................................4-1
1.1 Customize destinations (Maintenance mode 74) ..................................................4-3
1.2 Set the CIS type (Maintenance mode 59) .............................................................4-3
1.3 Install the firmware (Maintenance mode 28) .........................................................4-3
1.4 Initialize the EEPROM parameters (Maintenance mode 01).................................4-5
1.5 Restore the head calibration data (Maintenance mode 68)...................................4-5
1.6 Set the serial number (Maintenance mode 80) .....................................................4-5
1.7 Updating of head property data (Maintenance mode 68)......................................4-6
1.8 Restore machine information (Maintenance mode 46)..........................................4-6
1.9 Adjust the touch panel (Maintenance mode 78)....................................................4-7
1.10 Acquire white/black level data (Maintenance mode 55)........................................4-7
1.11 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65).........................................................................................4-7
1.12 Updating of paper feeding correction values (Maintenance mode 58)..................4-7
1.13 Adjustment of margins in borderless printing (Maintenance mode 66) .................4-7
1.14 Reset purge and flushing counts...........................................................................4-7