Brother MFC260C User Manual

4-5 Confidential
Error Message Cause Action
(On color LCD) *
Unable to Change XX
Unable to Clean XX
Unable to Init. XX
Unable to Print XX
Unable to Scan XX
Unable to use Phone XX
(On monochrome LCD) *
Change Unable XX
Clean Unable XX
Init. Unable XX
Print Unable XX
Scan Unable XX
The machine has a
mechanical problem.
or
A foreign object such as a
clip or ripped paper is in the
machine.
Open the scanner cover and remove any
foreign objects inside the machine.
If the error message continues, see
Chapter 5, Section 5.1
"TRANSFERRING RECEIVED FAX
DATA" before disconnecting the
machine so you will not lose any
important messages. Then, disconnect
the machine from the power for several
minutes and then reconnect it.
(The
machine can be turned off for
approximately 24 hours without losing
faxes stored in the memory.)
(On color LCD)
Unusable Device
Disconnect device
from front connector
& turn machine off &
then on
(On monochrome LCD)
Unusable Device
Disconnect device
from front connector.
Turn the machine off
& on by pressing
On/Off button on
control panel.
A broken device has been
connected to the USB direct
interface.
Unplug the device from the USB direct
interface, then press On/Off (Power
Save) to turn the machine off and then
on again.
Unusable Device
Please Disconnect
USB Device.
A USB flash memory drive
that is not supported has been
connected to the USB direct
interface.
Unplug the device from the USB direct
interface.
Wrong Paper Size Paper is not the correct size. Load the correct size of paper (Letter,
Legal or A4), and then press Black
Start (Mono Start) or Color Start.
* XX represents one of the error codes shown in "[ 2 ] Error codes contained in "MACHINE ERROR X X"
messages."

Brother MFC260C Specifications

General

Brand	Brother
Model	MFC260C
Category	Fax Machine
Language	English