6-36 Confidential
6.1.11 Ink Cartridge Cover, Media Module Cover, Front Cover, and WLAN PCB*
* For wireless LAN-enabled models
(1) Lightly lift up the front end of the lower cover and remove the ink cartridge cover.
(2) Remove the media module cover.
(3) For wireless LAN-enabled models: Proceed to step (4).
For models not supporting wireless LAN: Lightly pull up the retainer on the inside of the front
cover to release it from the lower cover. Then lightly lift up the front end of the lower cover
and remove the front cover.
(6_31)
Actuator leve
Cover arm
Main PCB shield
Retainer
Latch
Media module cover
Ink cartridge cover
Latch
Front cover
Boss
Boss
Sockets
Linear boss