Brother MFC260C User Manual

7-26 Confidential
[ 5 ] Register base ID code to the main PCB and base unit (cordless PCB)
The following procedure registers the base ID code to both the main PCB and base unit (cordless
PCB) at the same time. For the registration procedure of cordless handsets, see [14] below.
(1) Read the base ID code from the label attached to the rear of the machine.
NOTE: The code may be 8 or 10 digits long depending upon the machine models.
(base_ID_code_label_MFC)
Base ID code label
(2) On the machine, press the Menu, Black Start (Mono Start), , , , in this order.
The machine enters the maintenance mode and displays the "
" on the
LCD.
(3) Press the 0, 0, 8, and 6 keys in this order.
The current base ID code registered appears on the LCD.
ID: XXXXXXXX
(4) If the displayed code is different from the one read in step (1), move the cursor to the digit to be
modified, using the
and keys, and then enter the one read in step (1). To enter numerals,
use the numerical keys; to enter alphabets A through F, use the
and keys.
NOTE: To cancel the procedure halfway, press the Stop/Exit key.
(5) Press the OK key.
If the registration completes normally, the "COMPLETE" appears on the LCD.
NOTE: If the "FAILED" appears, the registration has failed. Go back to step (2) above.
(6) Wait two seconds for the screen to return to the initial stage of the maintenance mode and
display the "
."
(7) Press the 9 key twice to return to the standby state.
[ 6 ] Check the control panel PCB for normal operation (Function code 13)
Refer to Chapter 9, Section 9.1.4.7.
[ 7 ] Check the sensor operation (Function code 32)
Refer to Chapter 9, Section 9.1.4.8.

Brother MFC260C Specifications

General

Brand	Brother
Model	MFC260C
Category	Fax Machine
Language	English