Brother MFC260C User Manual

7-30 Confidential
[ 15 ] Register cordless handsets
--------------------------------------------------- USA models -------------------------------------------------------
On the cordless handset
(1) Press the Menu/OK key.
(2) Press the
or key to choose "Register HS," then press the Menu/OK key.
The cordless handset enters the registration mode.
On the machine (base unit)
Complete steps (3) through (6) below within two minutes from the entry of the registration mode.
(3) Press the Menu key.
(4) Press the
or key to choose "Initial Setup," then press the OK key.
(5) Press the
or key to choose "Register Handset," then press the OK key.
(6) Press the
or key to choose "Register," then press the OK key.
The "Registering" appears on the LCD.
Upon successful end of registration, the machine sounds a long beep.
Notes • If the machine sounds three short beeps, indicating the failure of registration, it returns to
the "Register Handset" state. Perform steps (2) and (6) again.
• If you want to install another cordless handset, repeat steps (1), (2), and (6).
• Up to four cordless handsets can be registered to the machine.
(7) Press the Stop/Exit key. The machine returns to the standby state.
----------------------------------------------- European models ----------------------------------------------------
On the machine (base unit)
(1) Check the PIN code of the base unit with Function code 80 in the maintenance mode. (Refer to
Chapter 9, Section 9.1.4.22.)
On the cordless handset
(2) Press the Menu/OK key.
(3) Press the
or key to choose "Register HS," then press the Menu/OK key.
(4) Press the
or key to choose any one of "Base1," "Base2," "Base3," and "Base4," then press
the Menu/OK key.
Note: Only unused base unit can be chosen.
The cordless handset enters the registration mode.
On the machine (base unit)
Complete steps (5) through (9) below within two minutes from the entry of the registration mode.
(5) Press the Menu key.
(6) Press the
or key to choose "Initial Setup," then press the OK key.
(7) Press the
or key to choose "Register Handset," then press the OK key.
(8) Press the
or key to choose "Register," then press the OK key.

Brother MFC260C Specifications

General

Brand	Brother
Model	MFC260C
Category	Fax Machine
Language	English