9-33 Confidential
9.1.4.16 Margin Adjustment in Borderless Printing (Function code 66)
îš„ Function
This function allows you to adjust the left and right margins for borderless printing. You print out a
margin check pattern, measure the left and right margins, and enter the correction values.
îš„ Operating Procedure
(1) Switch on your PC.
(2) Place the machine in the maintenance mode (see Section 9.1.1) and set letter-size paper to print
a margin check pattern.
(3) Connect the machine to your PC using a USB cable.
(4) On the PC, run "filedg32.exe" in the folder created in Section 7.1.1.
The Filedrgs window appears as shown below.
(5) Drag and drop the "media.prn" onto the BHL2-Maintenance Printer icon in the Filedrgs window
shown above.
The machine displays the "RECEIVING DATA" on the LCD and prints out the "MEDIA
CHECK" pattern (see page 9-35 for a sample printout).
(6) Measure the left and right margins on the printout.
(Example) Left: 1.3 mm, Right: 1.4 mm
If both margins are within the range from 0.9 to 1.1 mm, no adjustment is required.
To Next Page
Loading...
Need help?
General
