EasyManuals Logo

Brother MFC260C User Manual

Brother MFC260C
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
4-36 Confidential
Problem Action to be taken
(10) White horizontal streaks
• Perform the purging operation (Function code 76) several
times to remove dust or air bubbles from its nozzles. (Refer to
Chapter 9, Section 9.1.4.21.)
• Replace the head/carriage unit.
• Check the paper feed-related rollers.
• Perform the print head skew compensation with the head skew
adjuster knob. Refer to Chapter 7, Section 7.2, [ 4 ].
• Clean the head caps and wiper of the maintenance unit with a
Rubycel stick. For the cleaning procedure, refer to Chapter 8,
Section 8.2 "CLEANING THE MAINTENANCE UNIT."
(11) Stained leading edge of
recording paper
Printer
• Press the Ink (Ink Management) key to perform a head
cleaning operation.
• Check that the head/carriage unit is set into place.
• Check the height adjustment mechanism of the head/carriage
unit (Refer to Chapter 3, Section 3.2.2.3.)
• If the "head-platen gap offset" is enabled with assurance mode
switch AMS 02 (Function code 88), align the vertical print
lines (Function code 65). (Refer to Chapter 9, Sections 9.1.4.
25 and 9.1.4.15.)
(12) Overlapping or separated
lines over the whole page
• Adjust the paper feeding correction value of the paper feed
roller with Function code 58 in the maintenance mode. (Refer
to Chapter 7, Section 7.2, [ 5 ].)
• Perform the print head skew compensation with the head skew
adjuster knob. Refer to Chapter 7, Section 7.2, [ 4 ].
(13) Overlapping or separated
lines at the trailing edge of the
recording paper
• Adjust the paper feeding correction value of the paper ejection
roller with Function code 58 in the maintenance mode. (Refer
to Chapter 7, Section 7.2, [ 5 ].)
(14) Characters having shadows
(ghost)
VWXYZ
• Adjust the paper feeding correction values of the paper feed
roller and paper ejection roller with Function code 58 in the
maintenance mode. (Refer to Chapter 7, Section 7.2, [ 5 ].)
• Correct the positioning error of the head/carriage unit with
Function code 63 in the maintenance mode. (Refer to Chapter
7, Section 7.2, [ 4 ].)
• Replace the PF encoder disk.
• Replace the PF encoder PCB.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother MFC260C and is the answer not in the manual?

Brother MFC260C Specifications

General IconGeneral
BrandBrother
ModelMFC260C
CategoryFax Machine
LanguageEnglish

Related product manuals