9-49 Confidential
AMS01
(Printing assurance 1)
Selector
No.
Function Setting and Specifications
1
Prevention of stains on back side of
leading edge of paper in borderless
printing
0: Disable (default) 1: Enable
2
Reduction of banding in borderless
printing
(Limit of the number of head nozzles
to be used)
0: Disable 1: Enable
(No limit) (Limit)
3
4
Protection of platen from no-paper
printing to prevent stains
(Functional restriction on the paper
width sensor)
No. 3 4
0 0 : Enable (Determine the sensor
function depending upon the print
resolution selected) (default)
0 1 : Enable (Detect the leading edge
plus right and left edges of paper)
1 0 : Enable (Detect the leading edge
of paper)
1 1 : Disable (No paper detection)
5
Assurance print 1
(Printing with black and cyan inks in
monochrome copy)
0: Disable (default) 1: Enable
6
Assurance print 2
(Printing with black and cyan inks in
monochrome FAX reception and in
list output)
0: Disable (default) 1: Enable
7
8
Workaround for false jam detection
(Functional restriction on the paper
width sensor)
No. 7 8
0 0 : Detect both the leading edge and
width of paper (default)
0 1 : Detect both the leading edge and
width of paper
1 0 : Detect only the leading edge of
paper
1 1 : No detection
 Selector 1: Prevention of stains on back side of leading edge of paper in borderless printing
Setting this selector to "1" reduces the protruding amount of the leading edge of recording paper to
the platen groove to minimize stains that could be caused by ink mist on the back side of the leading
edge. Enabling this function reduces the throughput than disabling it.
 Selector 2: Reduction of banding in borderless printing (Limit of the number of head nozzles to be
used)
Setting this selector to "1" limits the number of head nozzles to be used in borderless printing to
reduce banding.
The default setting of this selector is "0" for models with movable platen, and "1" for models without
movable platen.
To Next Page
Loading...
Need help?
General
