1 - 29
1.2.21 Check Holder Adaptor AD
Checks that the power is supplied normally by connecting the AC adapter to the optional
battery base unit.
(1) Connect the AC adapter to the optional battery base unit first, and then remove the Li-ion
rechargeable battery.
(2) Make sure that the "Check holder adaptor AD" field is highlighted in yellow and press the
[Run] button to start the inspection.
Figure 46. "Check holder adaptor AD" start-up
(3) A/D value to be checked appears in the "Ad" field. Once "OK" appears for all items, the
inspection finishes automatically.
Note : If any item is not "OK", press the [NG] button to finish the inspection.
Figure 47. "Check battery holder" window
Conditions required for OK
"Adaptor State" indicates that the AC adapter connector detected "in" (connected).
Model Inspection
TD-2000 Invalid
TD-2100N Valid
To Next Page
Loading...
