Brother TD-2020 - 4 ] Attaching the Cover Open Sensor and Movable Sensor PCB ASSY

III - 31
[ 4 ] Attaching the Cover Open Sensor and Movable Sensor PCB ASSY
(1) Set the cover open sensor and SW hold plate to the upper cover, and secure it
with the taptite bind B M2.6X6 screw.
(2) Set four tabs on the movable sensor PCB ASSY to four notches on the upper
cover, and slide the movable sensor PCB ASSY so that the marking is aligned to
the one on the upper cover.
Figure 3.5-6
Tabs
Movable sensor PCB ASSY
Markings
Movable sensor
PCB ASSY
Cover open sensor
SW hold plate
Tabs
Taptite bind B M2.6X6
Upper cover
Upper cover