Brother TD-2020 - 2 ] Attaching the Adjuster Rack L;R and Adjuster Gear

III - 28
[ 2 ] Attaching the Adjuster Rack L/R and Adjuster Gear
(1) Attach the film spring 2 as described in the figure below.
(2) Secure the roller guide roller firmly, and attach the roller guide roller to the
adjuster rack L with the taptite cup B M2.6X6 screw. Stick the film spring to the
adjuster rack L.
(3) Secure the roller guide roller firmly, and attach the roller guide roller to the
adjuster rack R with the taptite cup B M2.6X6 screw.
(4) Set the adjuster lock spring in between the bosses of adjuster lock and adjuster
rack R. Set the adjuster lock to the adjuster rack R, and secure it with the two
taptite cup B M2.6X6 screws.
(5) Set the adjuster rack L and the adjuster rack R to the upper cover.
Figure 3.5-3
Taptite cup B M2.6X6
Roller guide rollers
Taptite cup B M2.6X6
Boss
Adjuster rack R
Adjuster
lock spring
Boss
Taptite cup B
M2.6X6
Adjuster lock
Upper cover
Film spring
Adjuster rack L
Film spring 2