III - 26
3.5 ASSEMBLY PROCEDURE
[ 1 ] Assembling the Mecha ASSY
(1) Attach the front cover B to the sub plate with the two screw bind M3X4 screws.
(2) Attach the platen bushing R to the main chassis R with the screw bind M2X3 screw.
NOTE: When tightening the screw, push the platen bushing R in the direction of the
arrow A to reduce rattle.
(3) Attach the main chassis R to the sub plate with the two screw bind M3X4 screws.
(4) Attach the platen bushing L to the main chassis ASSY with the screw bind M2X3
screw.
NOTE: When tightening the screw, push the platen bushing L in the direction of the
arrow B to reduce rattle.
(5) Insert the platen roller shaft (non D-cut surface) into the platen bushing R.
(6) Attach the main chassis ASSY to the sub plate with the two screw bind M3X4 screws.
(7) Stick filament tape (W: 9mm X L: 35 ± 5mm) to the main chassis ASSY and main
chassis R.
NOTE: Stick the filament tape so that it covers the frame edge.
Figure 3.5-1
Filament tape
Platen bushing L
Platen roller
Platen bushing R
Main chassis R
Filament
tape
Screw bind
M2X3
Main chassis
ASSY
Screw bind M3X4
Sub plate
Screw bind M3X4
Front cover B
D cutout surface
Screw bind M3X4
A
B
To Next Page
Loading...
