1 - 38
1.3.3 Output Buffer Data
Outputs data required for the machine analysis as a binary file (*.bin). It can be used when the
investigation of the causes for the BIL is needed. Follow the instructions given by serviceman to
use this tool properly.
(1) Check that the machine is turned ON and connected to the PC with USB cable.
(2) Make sure that the inspection item on the main screen is highlighted in yellow and press
the [Run] button.
Figure 65. "Output buffer data" start-up
(3) The message below appears when the machine is receiving the data.
Figure 66. Receiving buffer data
(4) Once the receiving is completed, it requests the binary file name to output. As a default,
the name is in "TD2000_YYYYMMDD_hhmmss.bin" format (YYYYMMDD: date,
hhmmss: time) but it is allowed to change this file name. Once the file name is entered,
press the [Save] button. File output starts.
Figure 67. "Buffer data directory" selection window
(5) Once the file output is completed, the message below appears in the "Results" field.
Figure 68. "Output buffer data" OK
To Next Page
Loading...
