Brother TD-2020 - 4 ] Removing the PCB Holder

III - 8
[ 4 ] Removing the PCB Holder
(1) Lift the release lever to open the roll cover ASSY, and remove the two taptite bind
B M2.6X8 screws. Close the roll cover ASSY and turn the machine upside down.
(2) Release each harness from the securing fixture.
(3) Remove the two taptite bind B M2.6X8 screws. Remove the PCB holder from the
machine, and pull out each harness from the two PCB holder holes.
Figure 3.4-6
PCB holder
Holes
Harnesses
Taptite bind B M2.6X8
Taptite bind B
M2.6X8
Roll cover ASSY
Release lever