Brother TD-2020 - Lubrication Points List

III - 2
3.3 LUBRICATION POINTS LIST
Platen gear
Double gear C
Double gear A
Tape feed motor gear
Double gear B
Apply Silicon grease G501 (4mm size)
on the mating teeth surface of the platen
gear and the double gear C.
Apply Silicon grease
G501 (4mm size)
on the shaft.
Apply Silicon grease G501
(4mm size) on the two
places of the mating teeth
surface of the double gear
C and the double gear B.
Apply Silicon grease G501 (4mm
size) on the two places of the
mating teeth surface of the double
gear B and the double gear A.
Apply Silicon grease G501 (4mm size)
on the mating teeth surface of the tape
feed motor gear and the double gear A.