III - 33
[ 6 ] Attaching the Head ASSY
(1) Stick the peeler sensor tape to the roll cover inner. (TD-2120N/2130N models only)
NOTE: Make sure that the tape is attached to three faces, not lifted nor peeled off.
(2) Connect the head harness ASSY 1 and head harness ASSY 2 to the head ASSY.
(3) Insert the two head harnesses and the FG harness ASSY into the two holes on the
roll cover inner. Set the head spring B in between bosses on the head ASSY and the
roll cover inner. Set the head ASSY to the roll cover inner while pushing it in the
direction of the arrow A and B.
Figure 3.5-8
Head ASSY
Boss
Head spring B
Roll cover inner
Boss
A
B
Head harness ASSY 2
(BL)
FG harness ASSY
Hole
Hole
Peeler sensor tape
(TD-2120N/2130N models only)
Head harness ASSY 1
(RD)
To Next Page
Loading...
