Brother TD-2020 - 12 ]Removing the Head ASSY

III - 18
[ 12 ]Removing the Head ASSY
(1) Pull up the head ASSY while pushing it in the direction of the arrow. Remove the
head ASSY and the head spring B from the roll cover inner, and pull out the two
head harnesses and the FG harness ASSY from the two holes of the roll cover
inner.
(2) Disconnect the two head harnesses from the head ASSY.
(3) Remove the peeler sensor tape from the roll cover inner. (TD-2120N/2130N
models only)
Figure 3.4-16
Head ASSY
Head spring B
Roll cover inner
FG harness ASSY
Head harness
Hole
Hole
Peeler sensor tape
(TD-2120N/2130N models only)
Head harness