Brother TD-2020 - 9 ] Attaching the Release Lever ASSY and Tear Bar

III - 36
[ 9 ] Attaching the Release Lever ASSY and Tear Bar
(1) Engage edge of the release spring to the hole of the shaft bushing of the roll
cover inner, and set the release lever ASSY to the two shaft bushings.
NOTE: Be careful not to scratch roll cover inner with the edge of the release
spring.
(2) Set the tear bar cap to the tear bar. Attach the tear bar to the roll cover inner with
two taptite bind B M2.6X6 screws.
Figure 3.5-11
Release spring
Taptite bind B
M2.6X6
Tear bar cap
Shaft bushing
Roll cover inner
Tear b a r
Release lever ASSY
Edge
Shaft bushing