1 - 21
1.2.14 Print Test (Label)
Checks the print quality as well as result of transmission and reflection sensor.
(1) Open the cover of the machine to set the inspection media for RDU F59X102 1 ASSY. Set
the media so that it comes out from the ejecting section, and close the cover.
(2) Make sure that the "Print test(Label)" field is highlighted in yellow and press the [Run]
button to start the inspection.
Figure 28. "Print test(Label)" start-up
(3) The media will be fed once the inspection starts. The machine stops feeding at the label
end and proceed to printing.
Note : When the optional touch panel display unit is connected and template is set in the
machine, the feeding length would be changed depending on the selected template.
This may result in wrong feeding position so disconnect the optional touch panel display
unit prior to the inspection. If the main PCB has been replaced and no template is set,
optional touch panel display unit may be connected.
(4) Once the printing is completed, [OK/NG] button appears on the tool. Check the print
quality (printed contents are aligned in the label and not be faded), and select one of the
buttons.
Figure 29. [OK/NG] selection window
Model Inspection
TD-2000 Valid
TD-2100N Valid
To Next Page
Loading...
