Brother TD-2020 - 9 ] Removing the Tear Bar and Release Lever ASSY

III - 15
[ 9 ] Removing the Tear Bar and Release Lever ASSY
(1) Remove the two taptite bind B M2.6X6 screws, and remove the tear bar from the
roll cover inner. Remove the tear bar cap from the tear bar.
(2) Turn the release lever ASSY in the direction of the arrow to remove it from the
two shaft bushings of the roll cover inner.
Figure 3.4-13
Taptite bind B
M2.6X6
Tear bar cap
Shaft bushing
Roll cover inner
Tear b a r
Release lever ASSY
Shaft bushing