1 - 10
1.2.6 Write Default EEPROM Data
Writes default settings by model and destination into EEPROM of the machine.
(1) This inspection starts automatically when the previous inspection is completed. When
operating this inspection again, check that the "Write default eeprom data" field is
highlighted in yellow, then press the [Run] button.
Figure 12. "Write default eeprom data" on process
(2) The inspection is completed when the data is successfully written. If the writing is failed,
error message appears in the "Results" field and the inspection ends up as NG.
Note : If you want to stop the writing after it's started, press the [Stop] button.
1.2.7 Write Media Information
Configures default media information data in the machine.
(1) This inspection starts automatically when the previous inspection is completed. When
operating this inspection again, check that the "Write media information" field is
highlighted in yellow, then press the [Run] button.
(2) The default media information will be written after the massage below appears.
Figure 13. "Write media information"
Model Inspection
TD-2000 Valid
TD-2100N Valid
Model Inspection
TD-2000 Valid
TD-2100N Valid
To Next Page
Loading...
