III - 44
(2) Close the roll cover ASSY and turn the machine upside down.
NOTE:
Roll shaft could drop when the left side of the machine is facing downwards.
Be careful not to lose it.
(3) Insert each harness into the two holes of the PCB holder. Set the PCB holder to
the machine and secure it with two taptite bind B M2.6X8 screws.
(4) Lift the release lever to open the roll cover ASSY, and tighten two taptite bind B
M2.6X8 screws from the front side.
Figure 3.5-19
PCB holder
Holes
Harnesses
Taptite bind B M2.6X8
Taptite bind B
M2.6X8
Roll cover ASSY
Release lever
To Next Page
Loading...
