92
Z31980_00_03
Configuration
Coil 1
On this page you can see the 12 coils which are controlled by the first Shim Control
Board. The resolution of the DAC which set the current to the coils is 16 bits. 0x000 is
the maximal negative current and 0xFFFF is the maximal positive current. This means
the half 0x8000 is zero current. In the column “current” you can read the current through
the coil. The next column ratio shows you the ratio of the current which flows the coils
and the current which should flow. This ratio should be near 1.
To Next Page
Loading...
