93
Z31980_00_03
Configuration
i
Note:if the current is close to zero, sometimes an error "insufficient current" is shown. If
you are not sure if a shim is responding, set a larger current (> 100mA) temporarily and
check that the error goes away.
Write DAC-Values to FRAM:
The DAC-Values will be saved to the onboard storage (non-volatile RAM)
Read DAC-Values from FRAM:
If you want to get the DAC-Values you have saved in the FRAM, you can choose this
option. Please remember, the values will only catch from the FRAM to the controller on
the Shim Control Board. After this operation you have to do the next operation “Get Dac-
To Next Page
Loading...
