Buderus Logamatic 4323 - Page 71

Heating circuit data
11
Logamatic 4323 - Subject to technical modifications.
71
The display shows the selected submenu.
Hold down "Display" and turn the rotary selector until the required value appears
(here: "yes").
The display shows the set value.
Release "Display" to save your input.
Setting the temperature rise
Here you can select the steps in which the temperature should increase
to
dry out the screed.
The temperature rise begins at 20 °C.
Turn the rotary selector until submenu "Screed drying Temp increase by"
appears.
The display shows the selected submenu.
Hold down "Display" and turn the rotary selector until the required value appears
(here: "10K").
The display shows the set value.
Release "Display" to save your input.
HEAT CIRC. DATA 2
no
Screed drying
+
HEAT CIRC. DATA 2
yes
Screed drying
Input range Factory setting
Screed drying
no
yes
no
USER INFORMATION
Parameters on the following pages enable you to select the temperatures
and
settings for the drying period.
The setting reverts automatically to "no" as soon as the drying process
has
been completed.
HEAT CIRC. DATA 2
5K
Temp increase by
Screed drying
+
HEAT CIRC. DATA 2
10K
Temp increase by
Screed drying
Input range Factory setting
Temp increase by
1 K – 10 K 5 K