Buderus Logamatic 4323 - Page 74

Heating circuit data
11
Logamatic 4323 - Subject to technical modifications.
74
Set setback time
By setting the "Setback" parameter, you determine in which daily cycle
the
temperature for drying the screed should be set back.
Turn the rotary selector until submenu "Screed drying Setback" appears.
The display shows the selected submenu.
Hold down "Display" and turn the rotary selector until the required value appears
(here: "every 5th day").
The display shows the set value.
Release "Display" to save your input.
Press "Back" to return to the next level up.
HEAT CIRC. DATA 2
every day
Setback
Screed drying
+
HEAT CIRC. DATA 2
every 5th day
Setback
Screed drying
Input range Factory setting
Setback in daily cycles
none
every
day – every 5th day
every day