2002 Buell S3T: Engine 3-13
HOME
CAUTION
See Figure 3-8. Do not attempt to remove the front isola-
tor mount from front cylinder head. Isolator mount is an
integral component and is not meant to be removed
unless absolutely necessary. Repeated removals and
installations will damage cylinder head threads.
10. Support motorcycle under front header mount. Do not
allow engine to drop when performing the next Step.
11. Continue loosening in 1/8-turn increments until screws
are loose. Remove head screws.
12. See Figure 3-9. Remove cylinder head (18), head gasket
(4), and O-rings (14).
NOTE
Front cylinder must be removed through upper triangular
frame members with front isolator mount attached.
13. See Figure 3-11. Remove both push rod covers (7) and
hydraulic lifters (6). See 3.15 HYDRAULIC LIFTERS.
14. Repeat the above procedure for the other cylinder head.
Figure 3-6. Removing Rocker Arm Shafts
5698
2
1. Position of Rocker Arm Retaining Bolts
2. Retaining Notch
1
Figure 3-7. Head Screw Loosening/Tightening Sequence
Figure 3-8. Front Isolator Mount (4th Tie Bar Not Shown)
b0336x3x
2
b0335x3x
2
3
4
1
4
3
Front Cylinder
Rear Cylinder
1
To Next Page