3-32 2002 Buell S3T: Engine
HOME
OIL HOSE ROUTING 3.8
GENERAL
See Figure 3-43. The oil tank has three fittings. From the top
of the tank, the vent hose (3) and the return hose (4) run
downward below the battery tray. Cable straps secure the
hoses in place.
A T-fitting (5) on the bottom of the oil tank supplies the feed
hose (1) and the drain hose (2). The drain hose (2) attaches
to the left side of the frame.
See Figure 3-44. The feed (1) and return hoses (3) run
together between the swingarm mount block and crankcase.
Protective covers prevent damage to the hoses. The hoses
continue on beneath the engine and forward to the oil pump.
The feed hose (1) attaches to the rear most oil pump fitting;
the return hose (3) connects forward and above.
After diverging from the feed and return hoses, the vent hose
is routed beneath the starter. It continues on to the right side
of the motorcycle. See Figure 3-45. Here the vent hose (1)
connects to an elbow fitting (3) on the gearcase cover (4).
Figure 3-43. Oil Tank Hoses
b0248a3x
2
1. Feed Hose
2. Drain Hose
3. Vent Hose
4. Return Hose
5. T-Fitting
1
4
3
5
Figure 3-44. Oil Pump Connections
Figure 3-45. Vent Hose Connection (Typical)
1
3
4
1. Feed Hose
2. Oil Pump
3. Return Hose
4. Oil Filter Hose
Connection
5709
2
b0344x3x
1. Vent Hose
2. Clamp
3. Elbow Fitting
4. Gearcase Cover
1
3
2
4
To Next Page
Loading...
