2002 Buell S3T: Engine 3-15
HOME
DISASSEMBLY
NOTE
Disassembly of front cylinder exhaust valve components
requires front isolator mount removal.
1. See Figure 3-10. Compress valve springs with VALVE
SPRING COMPRESSOR (Part No. HD-34736B).
2. See Figure 3-9. Remove valve keepers (7), upper collar
(8) and valve springs (5, 6). Mark valve keepers for reas-
sembly in their original locations.
3. Use a fine tooth file to remove any burrs on the valve
stem at the keeper groove.
4. Mark valve to ensure that it will be reassembled in the
same head. Remove valve (10), valve stem seal (11) and
lower collar (9).
5. Repeat the above procedure for the other valve.
6. Disassemble the other head using the same procedure.
Figure 3-10. Valve Spring Compressor
(Part No. HD-34736B)
5694
Valve Spring Compressor
Figure 3-11. Middle Valve Train Components
(Quantities per Engine Cylinder)
1. Right Crankcase Half
2. Anti-Rotation Screws with Washers (2)
3. Hydraulic Lifter (2)
4. Push Rod Cover (2)
5. Seal (2)
6. Retainer (2)
7. O-Ring (2)
8. Screw (2)
9. Push Rod (2)
10. Washer (2)
11. Locating Pin (2)
3
4
1
2
6
10
11
8
5
9
7
To Next Page