7-6 2002 Buell S3T: Electrical
HOME
INSTALLATION
1. Install ignition key switch.
a. Insert ignition key switch into hole of dash panel.
The word “TOP” stamped on the switch body should
face upward toward the lettering on the switch posi-
tion decal.
b. Apply LOCTITE THREADLOCKER 243 (blue) to
ignition key switch face nut.
c. Loosely install face nut.
2. See Figure 7-6 Attach ignition key switch connector [33]
to main wiring harness.
3. Tighten face nut to secure switch within dash panel.
4. Install negative battery cable to battery.
5. Check ignition key switch for proper operation. If opera-
tion fails, reread procedure and verify that all steps were
performed.
6. Install front fairing, mirrors and turn signals. See the
appropriate instructions in Section 2.
Figure 7-3. Ignition Headlamp Key Switch Connector
6500
Connector
To Next Page