Buell 2002 S3T - Page 91

2002 Buell S3T: Chassis 2-17
HOME
Table 2-5. Brake Troubleshooting
CONDITION CHECK FOR REMEDY
Excessive lever/pedal travel or
spongy feel.
Air in system.
Master cylinder low on fluid.
Bleed brake(s).
Fill master cylinder with approved
brake fluid.
Brake fade Moisture in system. Bleed brake(s).
Fill master cylinder with approved
brake fluid.
Chattering sound when brake is
applied.
Worn pads.
Loose mounting bolts.
Warped rotor.
Replace brake pads.
Tighten bolts.
Replace rotor.
Ineffective brake –
lever/pedal travels to limit.
Low fluid level.
Piston cup not functioning.
Fill master cylinder with approved
brake fluid, and bleed system.
Rebuild cylinder.
Ineffective brake –
lever/pedal travel normal.
Distorted or glazed rotor.
Distorted, glazed or contaminated
brake pads.
Replace rotor.
Replace pads.
Brake pads drag on rotor –
will not retract.
Cup in master cylinder not uncovering
relief port.
Rear brake pedal linkage out of
adjustment.
Inspect master cylinder.
Adjust linkage.