219I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Maintenance
12
Switch off the hot-water heater and allow it to cool down.
Open bleeding valve (Fig. 251,1) and leave open until no more air escapes.
Close bleeding valve.
Repeat this procedure at all bleeding valves.
Check to see if the hot-water heater warms up.
12.6.4 Position of the bleeding valves
Position of the bleeding valves
I 800
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the storage box of the divan
On the heat exchanger
In the kitchen to the side on the top drawer
On the steps to the rear bed to the right and left
I 810
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
Above the divan behind the curtain
In the lower cupboard to the left of the entrance
On the heat exchanger
In the kitchen to the side on the top drawer
On the garage flap directly on the heater
I 821
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
Above the divan behind the curtain
In the furniture cabinet at the left access
In the toilet compartment at the radiator
On the stairs to the rear bed
On the rear bed, left and right
On the heat exchanger
In the kitchen to the side on the top drawer
To Next Page
Loading...
