EasyManua.ls Logo

Burstner I 2012 - Rear Garage;Rear Storage Space

Burstner I 2012
292 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24 I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Before the journey
3
Climbing on to the roof (rear
ladder):
Hook the lower part of the ladder (Fig. 1,1) in the part of the ladder
(Fig. 1,2) which is fastened to the rear, and place it on the ground.
Carefully climb the ladder.
Climbing on to the roof
(telescopic ladder):
Carefully place the telescopic ladder (special equipment) against the side
of the vehicle.
Carefully climb the ladder.
3.3.5 Rear garage/rear storage space
Fig. 1 Rear ladder
X Observe the permissible axle loads and maximum permissible gross
weight when loading the rear garage/the rear storage space.
X The maximum permitted load of the rear garage/the rear storage space
is 200 kg. Do not exceed the permissible rear axle load.
X Observe: If the rear garage or (depending on the model) the rear storage
space is loaded to its maximum capacity, this will reduce the load on
the front axle due to the levering action. The driving quality is impaired.
Z Depending on the vehicle equipment, clamping rails with clamping eyelets
are mounted in the rear garage or in the rear storage space. Always secure
loads onto the clamping eyelets. Always use tightening straps or lashing
nets for securing the load, never rubber expanders.
Z When clamping loads, always check that the clamping eyelets are placed
tightly in the clamping rails. If the clamping eyelet is not anchored tightly in
the clamping rail, the load may slide or loosen during forcible movements
of the steering wheel or when braking.
Z Distribute the load evenly. Excessive spot loads can lead to damages of
the floor covering.
Z Use the supporting system offered by your dealer if two-wheelers are trans-
ported in the rear garage.

Table of Contents

Related product manuals