221I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Maintenance
12
Before the heating season starts, have the independent vehicle heater
checked by an authorised specialist workshop.
12.8 Replacing bulbs, external
Types of bulbs Different types of bulbs are used in the vehicle. Below, we have described how
to change the different types of bulbs.
X Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
X Store bulbs in a safe place inaccessible to children.
X Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Z A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Z Use only bulbs of the same type and with the correct wattage (see table
"Types of bulbs for exterior lighting").
Z If LEDs in lights are defect, contact an authorised dealer or service centre.
Fig. 252 Types of bulbs
Pos. in
Fig. 252
Fixture type/bulb
type
Changing
1 Plug-in fixture To remove, pull out the bulb
To mount, push the bulb into the socket
with gentle pressure
2 Bayonet socket To remove, press the bulb down and turn
in an anticlockwise direction
To insert, place the bulb in the socket and
turn in a clockwise direction
3 Cylindrical bulbs To remove and to insert, carefully bend the
contacts of the lamp holder outwards
4 Halogen bulb To remove, release retaining springs
After inserting, hook the retaining springs
again
To Next Page
Loading...
