220 I-Modell - 11/12 - Ausgabe 09/11 - 2096165 - BUE-0056-05EN
Maintenance
12
12.7 Independent vehicle heater
Use the independent vehicle heater for 10 minutes at least once a month with
a cold engine and smallest fan settings.
Position of the bleeding valves
I890
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the storage box of the divan
In the lower cupboard to the left of the entrance
On the heat exchanger
In the kitchen to the side on the top drawer
In the panelling next to the rear bed to the right and left
On the radiator in the bathroom
In the toilet compartment
In the rear garage (below the cover of the bed panels)
Position of the bleeding valves
I895
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the storage box of the divan
In the lower cupboard to the left of the entrance
On the heat exchanger
In the kitchen to the side on the top drawer
In the panelling next to the rear bed to the right and left
On the radiator in the bathroom
In the toilet compartment
In the rear garage (on the 3-way valve)
Position of the bleeding valves
I900
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the storage box of the divan
In the lower cupboard to the left of the entrance
On the heat exchanger
In the kitchen to the side on the top drawer
In the panelling next to the rear bed to the right and left
To Next Page
Loading...
