Chapter 2 BK730-2 Base Page 2-12
Purchase, installation, and calibration of these components must be completed by
qualified Buskro Ltd. Technicians
On a third party unit, some rewiring or modifications may be required to derive
and communicate the required signals
D1
DIP S2
DIP S3
To +12VDC
power
supply
To Base
Control
Board
To Front Panel
Production
Potentiometer
Status LEDs
Calibration
CAL POT C
CAL POT B
CAL POT A
To Dart Board or
AC Inverter
Manual/Auto
Calibration Switch
Figure 2-5: The Speed Control Board (p/n 9102421)
The universal speed control feature is beneficial because it allows operators to control the
production throughput for their application, regardless of the number of modules, from a
single location. This reduces job setup time and allows for operational changes to be
Buskro Ltd. BK730-2 Tabber
To Next Page
Loading...