Configuring 60 GHz cnWave™ 182
Figure 188:
The OCB section in the Networking page
PTP External failover
The PTP External Failover feature supports the failover of a 60 GHz cnWave RF link using external
devices such as PTP450 and ePMP.
Note
System Release 1.2.2 and later subsequent release versions support the external failover link
feature for Point-to-Point (PTP) links. The external failover interface must not be same as
PoP, Relay, or Out of Band (OOB) interface.
This feature does not support V1000 (which contains only one port).
Figure 189 shows how a 60 GHz cnWave PTP link is backed up with a PTP450 link. You can consider the
60 GHz link (as shown in Figure 189) as the primary link and 5 GHz link as the secondary link.
To Next Page