Cameron Scanner 3100 EFM - Appendix C-Firmware, Configuration, Scanner Logic, and Modbus Register Map Uploads; Firmware Uploads; Configuration Uploads; Register Map Uploads

Appendix C—Firmware, Conguration, Scanner Logic, and
Modbus Register Map Uploads
Firmware Uploads
The factory default rmware is easily restored using the Scanner 3100 web interface. Simply log into the Scanner 3100
interface, select ADMINISTRATION>GENERAL from the taskbar, then click Management at the left of the screen.
Under the “Firmware Management” section near the bottom of the screen, click Restore Firmware.
To upload new rmware, download the ScanFlash software utility and follow the upload instructions listed under Scan-
Flash Upload, page C-2.
Important To download ScanFlash software, visit Cameron’s Measurement website at http://www.cameron.
slb.com/owcomputers, choose CAMERON Flow Computer Scanner 3100, and click the link for the
software install.
Conguration Uploads
A user can load factory-set default conguration values, save the current conguration le, and upload an existing con-
guration le using the Scanner 3100 web interface. A conguration le can also be uploaded using ScanFlash software
utility.
• To make conguration changes from the web interface, select ADMINISTRATION>GENERAL from the taskbar,
then click Management at the left of the screen. Locate the “Conguration Management” section at the top of the
screen.
– To load default conguration values, click Load Conguration Defaults and click OK at the Conrm dialog
prompt.
– To save currently applied conguration values in a le that can be later uploaded to a Scanner 3100, right-click
the SCANNER 3100 CONFIGURATION FILE link, then click Save link as… Rename the le and/or change
the location where the le will be stored, if desired.
– To upload a conguration le that was previously saved to your computer, click Browse next to “Load
Conguration File,” select the desired conguration le to upload, and click Open. From the interface screen,
click Submit, click OK at the Conrm dialog, and wait for the le to upload.
• To upload a conguration le using ScanFlash, download the ScanFlash software utility and follow the upload
instructions listed under ScanFlash Upload, page C-2.
Important To download ScanFlash software, visit Cameron’s Measurement website at http://www.cameron.slb.
com/owcomputers, choose Scanner Model 3100 Flow Computer, and click the link for the software
install.
Register Map Uploads
Using Cameron’s ScanMap software, a user can create a set of user-dened Modbus register maps (.pmap) for custom-
izing Modbus communications protocols. A .pmap le can be uploaded to a Scanner 3100 using the Scanner 3100 web
interface or the ScanFlash software utility. Files are uploaded to the web interface by selecting Administration>
General>Installed Files.
Important To download ScanFlash or ScanMap software, visit Cameron’s Measurement website at http://www.
cameron.slb.com/owcomputers, choose Scanner Model 3100 Flow Computer, and click the link for
the desired software install. A ScanMap user manual is also available for download from this site.
C-1
Scanner 3100 EFM Appendix C