Connecting to the Scanner 3100
The WiFi modem is pre-congured at the factory to expedite user setup in the eld. To connect to the Scanner 3100 web
interface via the WiFi accessory,
1. Apply 110 VAC power to the modem. The modem will begin broadcasting its wireless signal momentarily.
2. From a laptop or other browser-enabled device, click on the “IPn4G+” wireless connection to connect to the WiFi
modem.
3. Locate and record the IP address displayed in the upper left corner of the Scanner’s LCD display.
4. Open a web browser on the laptop or other browser-enabled device and enter the Scanner 3100 IP address. The
Scanner 3100 web interface Device Login page will appear.
5. On the Device Login page, enter the appropriate user name and password. Default entries (case-sensitive) are:
User Name: admin
Password: scanner
6. Press the “Login” button on the screen.
Note If the loading stalls, click Refresh. If a connection to the Scanner is not established, verify the IP address and
repeat step 4.
Important Changing the administrative password after the initial login is strongly recommended. See the
“Security” section of the Scanner 3100 Web Interface User Manual for instructions on changing the
administrative password and setting up additional users with password-protected access.
Troubleshooting the Wireless Connection
If the modem fails to communicate with the Scanner 3100, consider the following steps to address the problem:
1. Open and close fuse F2 inside the WiFi box to reboot the modem.
2. Shut off the laptop and restart it.
3. If the modem is powered, but no wireless connectivity is detected on your computer or other browser-enabled
device, it may be necessary to reset the Scanner 3100 IP address. Please contact Cameron technical support for
assistance.
Adding Security to the WiFi Connection
WiFi security is disabled at the factory during initial modem conguration, but users can enable security by logging into
the modem web browser menu, as follows.
1. Open a web browser on a laptop or smartphone.
2. Enter the modem’s IP/port address, 192.168.168.1:8080.
3. When prompted, enter the following user name and password to access the main modem screen:
User Name: admin
Password: admin
4. Click the Wireless tab in the top bar, and the Radio 1 tab from the second bar at the top of the screen.
5. From the Radio 1 tab, locate the “Encryption Type” eld near the bottom of the screen.
6. Select an encryption type from the dropdown list.
7. Enter a password if desired, and click Submit.
77
Scanner 3100 EFM Section 4
To Next Page
Loading...
