4) Select the paper type duplicated in the step 3) and press "Details/Edit".
5) Select "Adjust Gross/Fine Black" and press "Change".
[Reference] In case Adjust Gross/Fine Black will not be displayed on the control panel, change the setting value of Service Mode
> Mode List > COPIER > Option > DSPLY-SW > IMGC-ADJ to "1". The value is "0" by default.
6) Press "-" button for gloss, Make sure the setting value [a] is set to "-1" and press "OK".
The setting range is from "-4" to "+4" ("0" by default).
Change of the setting value changes the fixing temperature.
3
To Next Page
Loading...
